Skip to main content
NetApp Knowledge Base

Is it possible to Increase the ILM scan rate beyond the default value of 400 on a StorageGRID VM-Based node?

  1. Last updated
  2. Save as PDF
Views:
81
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

  • StorageGRID 11.6 and above
  • VMWare based storage node

Answer

  • Essentially, you can increase the ILM scan rate from the default value of 400.
  • Please contact NetApp Technical Support or log into the NetApp Support Site to create a case. Reference this article for further assistance.

Additional Information

How to change ILM scan rate in StorageGRID 11.6 and newer releases

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.