Skip to main content
NetApp Knowledge Base

StorageGRID EC rebalance stops within seconds if target node would have >80% usage

  1. Last updated
  2. Save as PDF
Views:
19
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

NetApp StorageGRID 11.8

Issue

  • On a near full GRID with data load > 80%, after adding new node(s) and trying to run EC Rebalance it stops within seconds.
  • Job shows as success, but Site Imbalance shows calculating:
 

# rebalance-data status --job-id <job_id>
==============================================================================
Job ID : <job_id>
Site : <site_name>
State : Success
Planned Moves : 0
Completed Moves : 0
Failed Moves : 0
Start Time : 2024-12-14 06:45:44 UTC
End Time : 2024-12-14 06:45:50 UTC
Site Imbalance : Calculating
Retry Rebalance : No
==============================================================================

  • There are no errors in either rebalance-data.log or bycast.log on the EC leader node.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.