Skip to main content
NetApp Knowledge Base

StorageGRID reports hardware fault detected due to BMC event log being almost full

  1. Last updated
  2. Save as PDF
Views:
70
Visibility:
Public
Votes:
0
Category:
storagegrid-webscale
Specialty:
sgrid
Last Updated:

Applies to

  • NetApp StorageGRID
  • SG1100 appliance

Issue

  • A hardware fault has been detected in the compute controller alert present in StorageGRID alerts.
  • No hardware alert present in BMC for obvious hardware failure.
  • On affected node, run-host-command ipmitool sel list command reports the following:
    • 09/15/25 | 00:44:18 UTC | Event Logging Disabled #0x70 | Log almost full | Asserted

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.