Skip to main content
NetApp Knowledge Base

EC rebalance job failed with error failed to run command : 500

  1. Last updated
  2. Save as PDF
Views:
6
Visibility:
Public
Votes:
0
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

NetApp StorageGRID

Issue

  • Rebalancing erasure-coded data failed with error:
Requested rebalance operation failed.
Internal server error. The server encountered an error and could not complete your request. Try again. If the problem persists, contact support. Failed to run command: FAIL
  • The job starts and stops immediately and cannot be located while listing:

# rebalance-data status

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.