Skip to main content
NetApp Knowledge Base

Refresh Clone failure with message "The Oracle base has been set to "

Views:
38
Visibility:
Public
Votes:
0
Category:
snapcenter
Specialty:
snapx
Last Updated:

Applies to

SCO 4.8 and above

Issue

Refresh-SmClone command fails with sudo trying to get owner and group id for sqlplus command. The spl_*.log file from the failed job will show:
Execution Monitor Thread [sudo /opt/NetApp/snapcenter/spl/bin/sc_command_executor oracle "ls -ld '/orasw/oracle/product/19c/db/bin/sqlplus' | sed 's/[ ][ ]*/ /g' | cut -d' ' -f3"] c.n.c.e.ShellResult - EXE-00001: Shell result [0:00:00.118] (Exit Value: 0):
The Oracle base has been set to /orasw/oracle
oracle

This should result in just the single oracle value at the bottom.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.