Skip to main content
NetApp Knowledge Base

What are the differences between Destination and Unprotected as displayed in AIQUM?

  1. Last updated
  2. Save as PDF
Views:
44
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
OM
Last Updated:

Applies to

Active IQ Unified Manager (AIQUM)

Answer

The differences between the Protection Roles Destination and Unprotected as displayed in Volumes screen of INVENTORY on AIQUM are as follows:

  • Destination: When the volume type is DP or the volume is displayed as a destination in snapmirror show

Note: After snapmirror break is run, the volume remains as a destination in snapmirror show, but the volume type changes to RW

  • Unprotected: When the volume type is RW and the volume is not displayed as a source or a destination in snapmirror show

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.