Skip to main content
NetApp Knowledge Base

Search

  • Filter results by:
    • View attachments
    Searching in
    About 5 results
    • How to perform a system health check after a Data ONTAP upgrade or hardware replacement: Resolution Guide
      https://kb.netapp.com/on-prem/ontap/Ontap_OS/OS-KBs/How_to_perform_a_system_health_check_after_a_Data_ONTAP_upgrade_or_hardware_replacement__Resolution_Guide
      The procedure to be followed to perform a system health check after a Data ONTAP upgrade or hardware replacement is described in this article. AutoSupports will need to be triggered from all nodes aft...The procedure to be followed to perform a system health check after a Data ONTAP upgrade or hardware replacement is described in this article. AutoSupports will need to be triggered from all nodes after the upgrade/replacement is complete.
    • How to replace an E-Series DE460c controller/expansion shelf
      https://kb.netapp.com/on-prem/E-Series/Hardware-KBs/How_to_replace_an_E_Series_DE460c_controller_expansion_shelf
      Applies to E-Series DE460c SANtricity Array Management Window (AMW) SANtricity Management Software (MSW) SANtricity System Manager (SAM) Description This article describes the procedure to replace a D...Applies to E-Series DE460c SANtricity Array Management Window (AMW) SANtricity Management Software (MSW) SANtricity System Manager (SAM) Description This article describes the procedure to replace a DE460c enclosure with 5 drawers. Note: If the chassis replacement is due to a DOA situation and no data on the system yet, you can skip step 3 and step 17.
    • Failed drive on Element cluster
      https://kb.netapp.com/on-prem/solidfire/hardware_Kbs/Failed_drive_on_Element_cluster
      Alert for driveFailed on Element cluster in NetApp SolidFire Active IQ and in cluster alerts tab
    • AutoSupport Message: driveFailed on Element cluster
      https://kb.netapp.com/on-prem/solidfire/hardware_Kbs/AutoSupport_Message__driveFailed_on_Element_cluster
      AutoSupport Message: driveFailed on Element cluster in NetApp SolidFire Active IQ and in cluster alerts tab
    • WWNs changed after offline replacement of tray 0
      https://kb.netapp.com/on-prem/E-Series/SANtricity-OS-KBs/WWNs_changed_after_offline_replacement_of_tray_0
      Applies to E-Series systems with external trays SANtricity OS Issue After replacing tray 0 while the system was offline, the FC target port WWNs changed of all BASE and host interface card (HIC) ports