Skip to main content
NetApp Knowledge Base

OnCommand Unified Manager Acquisition Service on Windows host, fails to start after install

  1. Last updated
  2. Save as PDF
Views:
148
Visibility:
Public
Votes:
0
Category:
oncommand-unified-manager
Specialty:
om
Last Updated:

​ ​

Applies to

OnCommand Unified Manager 6.x 
OnCommand Unified Manager 7.x

The Content of this article only applies to instances of Unified Manager that are installed on a Windows host operating system.

Issue

OnCommand Unified Manager Acquisition Service fails to start after an installation on Windows. When attempting to start manually, the service starts briefly and then fails.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device