Skip to main content
NetApp Knowledge Base

LDAPS authentication works initially then fails in OnCommand Workflow Automation 5.1

  1. Last updated
  2. Save as PDF
Views:
170
Visibility:
Public
Votes:
0
Category:
oncommand-workflow-automation-wfa
Specialty:
om
Last Updated:

Applies to

OnCommand Workflow Automation

Issue

  • When configuring an authentication server in OnCommand Workflow Automation (WFA) 5.1, LDAPS authentication works initially for 30 minutes but then no longer works.
  • The configured authentication server address points to a load balancer instead of an authentication server.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device