Skip to main content
NetApp Knowledge Base

Repeated node panics due to SnapMirror relationships from a 7-mode system

Views:
15
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
7dot
Last Updated:

Applies to

ONTAP 9.8+
Data ONTAP 7 mode

Issue

After upgrading to ONTAP 9.8+ nodes continuously panic with page fault (supervisor write data, page not present) on VA 0 cs:rip 0x20:0xffffffff8df22ca7 rflags 0x10246 in SK process wafl_exempt07 on release 9.8P1 (C) due to the presence of active SnapMirror transfers from a 7-mode system.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device
  • Was this article helpful?