Skip to main content
NetApp Knowledge Base

Does 7 MTT require rebaselining after a physical relocation of 7-mode or C-mode systems?

  1. Last updated
  2. Save as PDF
Views:
12
Visibility:
Public
Votes:
0
Category:
7-mode-transition-tool
Specialty:
7dot
Last Updated:

Applies to

7-Mode Transition Tool (7MTT)

Answer

If the following points are followed, then there is no need to rebaseline:

  • Before relocating the system, pause all the 7MTT jobs and resume them only after the migration is completed.
  • The network and disk configurations must be the same before and after the relocation.
  • 7MTT must be able to connect to the system both 7-mode and C-mode systems from the new location.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device