Skip to main content
NetApp Knowledge Base

Can CIFS service be terminated on 7-mode before executing CFT?

  1. Last updated
  2. Save as PDF
Views:
276
Visibility:
Public
Votes:
0
Category:
7-mode-transition-tool
Specialty:
7dot
Last Updated:

Applies to

  • ONTAP 9
  • NetApp Data ONTAP operating in 7-Mode (7-mode)
  • 7-Mode Transition Tool (7MTT)
  • Copy-Free Transition (CFT)

Answer

No, If terminate the CIFS service on 7-Mode, It can not able to pass the CIFS prechecks and reports the following messages.

To enable the 7-Mode Transition Tool to perform CIFS prechecks and transition CIFS configurations,
start the CIFS service on the these 7-Mode storage systems by using the 7-Mode command: 'cifs restart'.
 

Additional Information

 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device