Skip to main content
NetApp Knowledge Base

7-Mode SnapMirror initialization fails with an abort after moving lots of data

Views:
60
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP 8 7-Mode
  • SnapMirror

Issue

  • SnapMirror fails with error "replication transfer failed to complete"
  • The initialization ran for a while, moving huge amount of data
  • Failure logged in the destination SM-log:
dst Tue Jun 14 22:46:40 PDT src-node:src-vol dst-node:dst-vol Abort (replication transfer failed to complete)
  • Failure logged in the source SM-log:
src Tue Jun 14 22:40:54 PDT src-node:src-vol dst-node:dst-vol Abort (Transfer failed)

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?