Skip to main content
NetApp Knowledge Base

H610S Reporting fault for incorrect bios setting "Current IPMI over LAN"

Views:
1,021
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
hci
Last Updated:

Applies to

  • NetApp H610S
  • NetApp Element 12.0 and lower
  • Baseboard Management Controller (BMC) firmware 3.84

Issue

Warning in cluster UI and NetApp SolidFire Active IQ:hardwareConfigMismatch     Incorrect bios setting "Current IPMI over LAN" should be == [FF]Unknown but is [01]Enabled

Note: Error only becomes visible after first reboot

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?