Skip to main content
NetApp Knowledge Base

Host initiators shows not logged in

Views:
22
Visibility:
Internal
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

This knowledge base was generated through a script and may contain formatting issues. For the accurate content, please refer to the WIP editor. WIP editor.

Applies to

  • * Cisco SAN switch
  • * RHEL 8.10

Issue

some of the host initiators shows not logged in after the cisco switch upgrade.



[cid:image001.png@01DAECD8.62884600]



Link break errors are seen in EMS Events:



[?] Tue Jul 30 18:14:20 +0530 [MX-DR-STO-N2: fct_tpd_work_thread_0:
scsitarget.slifct.linkBreak:error]: Link break detected on Fibre Channel target
HBA 2d with event status 1 , topology type 1, status1 0x0, status2 0x0.
[?] Tue Jul 30 18:14:20 +0530 [MX-DR-STO-N2: fct_tpd_work_thread_0:
scsitarget.slifct.linkBreak:error]: Link break detected on Fibre Channel target
HBA

[?] Tue Jul 30 18:14:21 +0530 [MX-DR-STO-N1: fct_tpd_work_thread_0:
scsitarget.slifct.linkBreak:error]: Link break detected on Fibre Channel target
HBA 2d with event status 1 , topology type 1, status1 0x0, status2 0x0.
[?] Tue Jul 30 18:14:21 +0530 [MX-DR-STO-N1: fct_tpd_work_thread_0:
scsitarget.slifct.linkBreak:error]: Link break detected on Fibre Channel target
HBA 3d with event status 1 , topology type 1, status1 0x0, status2 0x0.



[cid:image002.png@01DAECD8.62884600]

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

This is an internal KB article and its content should not be copy/pasted and shared with people outside of NetApp. Always seek Duty Manager authentication of caller for password reset requests. If you need further assistance post a question in Knowledge Xchange