Skip to main content
NetApp Knowledge Base

Is there a setting to enable advanced capacity balancing when creating a FlexGroup from Trident?

  1. Last updated
  2. Save as PDF
Views:
19
Visibility:
Public
Votes:
0
Category:
trident-openshift
Specialty:
snapx
Last Updated:

Applies to

  • ONTAP 9
  • FlexGroup
  • Trident

Answer

  • No, there is no setting to enable advanced capacity balancing from Trident.
  • It must be configured from on the ONTAP side after the FlexGroup has been created by Trident.

Note: Once advanced capacity balancing is enabled. it could not be disabled.

Additional Information

Balance ONTAP FlexGroup volumes by redistributing file data

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.