Skip to main content
NetApp Knowledge Base

StorageGRID: how to use iperf in 11.3 or iperf3 on 11.4 and higher

  1. Last updated
  2. Save as PDF
Views:
717
Visibility:
Public
Votes:
8
Category:
storagegrid
Specialty:
sgrid
Last Updated:

Applies to

  • NetApp StorageGRID
  • StorageGRID releases: 11.3 and later

Description

  • To be able to use iperf on StorageGRID 11.3, port 5001 needs to be opened temporarily.

ONTAP 9.7 network test-link command uses iperf3, default port 5201.  This command is available to cluster administrator at the advanced privilege level

  • For iperf3 on StorageGRID 11.4, port 5201 needs to be opened temporarily.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.