Skip to main content
NetApp Knowledge Base

How to upgrade NIC firmware on HCI compute nodes using CLI

Views:
1,131
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
hci
Last Updated:

Applies to

  • NetApp HCI H300E compute node
  • NetApp HCI H500E compute node
  • NetApp HCI H700E compute node
  • NetApp HCI H410C compute node
  • VMware ESXi 6.5
  • VMware ESXi 6.7

Description

  • After upgrading NetApp HCI components you noticed that the NIC firmware version on ESXi hosts is not the latest supported by NetApp.
  • NetApp HCI environment was installed without using NetApp Deployment Engine.
  • You need procedure to upgrade NIC firmware on ESXi hosts using CLI.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.