Skip to main content
NetApp Knowledge Base

Are Broadcom BES-53248 switches supported with NetApp HCI?

  1. Last updated
  2. Save as PDF
Views:
156
Visibility:
Public
Votes:
3
Category:
netapp-hci
Specialty:
hci
Last Updated:

Applies to

  • NetApp HCI
  • Broadcom BS-53248 switches

Answer

No. Broadcom BES-53248 switches do not support separate bonding modes on different switch ports.

Additional Information

From the admin guide:

Non-redundant ports: Ports on either of the peer switches that are not part of the VPC (ports P4 and S4). VPC interfaces and non-redundant ports cannot be members of the same VLAN, i.e. a VLAN may contain VPC interfaces or a VLAN may contain non-redundant ports, but not both.
 
FDB entries learned on VPC interfaces are synced between the two devices. In the case where all VPC member ports are UP, data traffic does not traverse the peer link.

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.