Skip to main content
NetApp Knowledge Base

What is default FEC mode of Mellanox 25GbE port on HCI?

Views:
1,080
Visibility:
Public
Votes:
2
Category:
netapp-hci
Specialty:
hci
Last Updated:

Applies to

H610

Answer

25GbE port on H610 is a Mellanox ConnectX-4 Lx ethernet adapter. According to Mellanox community article, the FEC mode is auto-negotiate by default. If the other side supports FEC, FEC is then enabled. If not, FEC is then disabled.

Additional Information

FEC modes supported of Mellanox ConnectX-4 Lx ethernet adapter are AU(Auto)/NF(No-FEC)/FC(FireCode FEC)/ RS(RS-FEC)

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.