Skip to main content
NetApp Knowledge Base

NetApp H610S cannot access to BMC after setting Shared NIC

  1. Last updated
  2. Save as PDF
Views:
635
Visibility:
Public
Votes:
0
Category:
h-series
Specialty:
hci
Last Updated:

​ ​

Applies to

NetApp H610S

Issue

Unable to access BMC neither through the dedicated port nor management port when shared NIC is configured for management and BMC interfaces

Current BMC LAN Port State will be shown as  Unknown on BIOS

This is an example screenshot of BIOS settings:
NetApp H610S cannot access to BMC after setting Shared NIC

Note: For safety reasons, Station IP address, Station MAC address and Router IP address is blurred out at the example screenshot

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.