Skip to main content
NetApp Knowledge Base

H610S - BMC can't be accessed after some maintenance on the node

Views:
365
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:

Applies to

NetApp H610S

Issue

The BMC can't be accessed in below scenarios:

  • After the node is performed power drain reboot as the following procedure
  • After the node is performed upgrade
  • After RTFI or iRTFI the node(Add node)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?