Skip to main content
NetApp Knowledge Base

ONTAP 9.6 and later: Weekly SPARES_LOW Autosupport are being sent following a disk replacement

Views:
1,922
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9.6 and later
  • Root Data Data partitioning (ADPv2)
  • Platforms with a Dedicated core dump device. Example:
    • AFF A250, FAS500f
    • AFF A400, FAS8700, FAS8300
    • AFF A220, FAS2750, FAS2720
    • AFF A700, FAS9000
    • AFF A800
    • AFF A320
    • AFF A300
    • AFF A700s

Issue

  1. After a disk replacement and correct assignment, ONTAP reports weekly SPARES_LOW Autosupport
  • There is an Alert after a partitioned disk fails. This happens even when there is a full spare available on the node after the replacement.
Fri Jun 18 16:00:00 -0400 [node_name: config_thread: callhome.spares.low:error]: Call home for SPARES_LOW
  1. Checking for available spares will only show root partitions (P3) and one full disk available

Example:

cluster::> node run -node * sysconfig -r
[...]

node-01
Pool0 spare disks

RAID Disk    Device      HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
---------    ------      ------------- ---- ---- ---- ----- --------------    --------------
Spare disks for block checksum
spare       0b.00.10P3    0b    0   10  SA:A   0   SSD   N/A 23956/49062912    23964/49079296
spare       0b.00.11P3    0b    0   11  SA:A   0   SSD   N/A 23956/49062912    23964/49079296

[...]

node-02
Pool0 spare disks

RAID Disk    Device      HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
---------    ------      ------------- ---- ---- ---- ----- --------------    --------------
Spare disks for block checksum
spare       0b.00.22P3    0b    0   22  SA:B   0   SSD   N/A 23956/49062912    23964/49079296
spare       0b.00.15    0b    0   15  SA:B   0   SSD   N/A 915465/1874872832 915715/1875385008

Note: The error doesn't impact the cluster if the failed disk was already replaced. If another partitioned disk fails ONTAP will partition the available spare by default.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.