LUN not visible in a "lun show" command output

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 735

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: san

Last Updated:

Applies to

ONTAP 9.4P6 and above
SAN

Issue

LUN not visible in lun show, however, it is visible on a full path.
LUN is also not visible in Autosupport.
debug smdb table d_vdisk_lun show shows LUN type correctly, however, vdom dump -metafile vtoc shows namespace and flag is not 0:

Example:

::*> debug smdb table d_vdisk_lun show -node NETAPP -dsid 5846 -type-filter all -fields type node dsid snapshot qtree lun type --------------- ---- -------- ----- ---------------------- ---- NETAPP 5846 "" "" test_lun.lun lun

::*> node run -node * -command vdom dump -metafile vtoc -d 5846 -h 4 entries were acted on. Node: NETAPP VTOC Header Contents --------------------- Magic Number: 1668248694 Major Version: 3 Minor Version: 2 Volume Flags: 0 Vdisk Count: 1 Sync op ctx: 0 Sync op gsid: 0 Namespace Name: test_lun.lun Base fileid: 97 Record Contents: Base generation: 1200408254 Clone parent fileid: 0 Clone parent generation: 0 Clone snapid: 0 Flags: 2 vdom dump vtoc: found 1 records in 1 msecs