Skip to main content
NetApp Knowledge Base

Command 'power show' fails with ' Error: The Service Processor on node "Node-02" is not reachable'

Views:
1,777
Visibility:
Public
Votes:
2
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • AFF Systems
  • FAS Systems
  • ONTAP 9

Issue

  • Error while running the command: system node power show
Cluster::> power show
(system node power show)

Node Status
---------------- -----------
node1 on

Error: The Service Processor on node "node2" is not reachable. Check the
network configuration, verify that the node is running, verify that the
SP is online, verify that api-service is enabled on the SP, and try the
command again.
node2 -
2 entries were displayed.
  • The command is failing for all the node except the node hosting cluster-mgmt LIF.
  • In above output, node1 is hosting the cluster-mgmt LIF and the command is working for node1.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?