Skip to main content
NetApp Knowledge Base

AFF A300/FAS8200 BIOS POST Failure(s) detected: PCIe device missing error detected. Abort AUTOBOOT

Views:
6,340
Visibility:
Public
Votes:
2
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • AFF A300
  • FAS8200

Issue

  • Node fails to boot with the following message:

BIOS POST Failure(s) detected: PCIe device missing error detected. Abort AUTOBOOT

  • The controller does not boot with the following console error:

Boot Loader version 6.0.5 
Copyright (C) 2000-2003 Broadcom Corporation.
Portions Copyright (C) 2002-2018 NetApp, Inc. All Rights Reserved.
BIOS POST Failure(s) detected: PCIe device missing error detected. Abort AUTOBOOT

  • Service Processor events report:

Record 1163: Sun Jun 27 13:58:41 2021 [SysFW.notice]: Device 16/0/0 (CNA0) missing
Record 1164: Sun Jun 27 13:58:41 2021 [SysFW.notice]: Device 17/0/0 (CNA1) missing

  • Panic may also be observed on subsequent boot attempts:

Eth_ntap_name: platform_devname unable to find device XX:0:0
PANIC : make_dev_sv: bad si_name (error=22, si_name=)

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?