Skip to main content
NetApp Knowledge Base

"Power outage protection flash de-staging: invalid" message observed during an ONTAP upgrade

Views:
880
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

  • AFF-A700
  • ONTAP upgrade to 9.7P8

Issue

While performing an ONTAP upgrade, an invalid status is printed instead of the expected cycle value during boot:

Nov 05 22:50:40 Power outage protection flash de-staging: 10 cycles
Nov 06 01:02:44 Power outage protection flash de-staging: invalid

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.