Skip to main content
NetApp Knowledge Base

How to install E-Series SANtricity Management software through the command line (CLI)

Views:
321
Visibility:
Public
Votes:
1
Category:
e-series-santricity-management-software
Specialty:
esg
Last Updated:

Applies to

Flash Array

Description

In some instances, it is necessary to install E-Series SANtricity where a GUI (Graphical User Interface) is not available. This might be because the user has access to a host only through a remote terminal (such as SSH or Telnet), or because the host to be installed does not have a GUI. 

This article describes how SANtricity can be installed in such cases.

Note: This procedure is only for the legacy E-Series SANtricity Management Client. This procedure cannot be performed on the Web Based SANtricity System Manager.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.