Skip to main content
NetApp Knowledge Base

Why does Brocade 6510-48 switch show port number more than 47?

Views:
330
Visibility:
Public
Votes:
0
Category:
thirdparty
Specialty:
san
Last Updated:

Applies to

Brocade

Issue

Brocade 6510-48 is 48-Port Fibre Channel SAN switch, usually the output of command "switchshow" shows port range from 0 to 47. 

Why some switch show ports number more than 47 like below?

Example:

SW6510_TACX_8:FID21:admin> switchshow

switchName:     SW6510_TACX_8

switchType:     109.1

switchState:    Online   

switchMode:     Native

switchRole:     Subordinate

switchDomain:   81

......................

  46  46   512e00   --    N16      No_Module   FC  (No POD License) Disabled

  47  47   512f00   --    N16      No_Module   FC  (No POD License) Disabled

  48  48   ------   --    --       Online      FC  E-Port  10:00:c4:f5:7c:53:82:79 "DCX8514_1" (upstream)

  49  49   ------   --    --       Online      FC  E-Port  10:00:c4:f5:7c:90:3f:50 "SW6510_TACX_4" 

  50  50   ------   --    --       Online      FC  E-Port  10:00:c4:f5:7c:90:0b:68 "SW6510_TACX_6" 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.