Skip to main content

NetApp wins prestigious Coveo Relevance Pinnacle Award. Learn more!

INSIGHT Japan :2023年 1月25日(水)ANAインターコンチネンタルホテル開催 へ参加・申込を行う

NetApp Knowledge Base

Upgrading an X7 switch directly to FOS v9.1.x from FOS v9.0.x result in the active CP becoming non-responsive as per Brocade TSB 2022-286-A

Views:
73
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade X7-8 and X7-4 switches 
  • All other platforms are not at risk to encounter this issue

Issue

  • Upgrading an X7 Director directly to FOS v9.1.x from FOS v9.0.x after performing a “firmware clean install” operation with the FOS v9.0.x firmware will result in the Active CP becoming non-responsive.
  • After an upgrade to FOS v9.1.x, the Active CP will show FAULTY (53) and will essentially be unresponsive. No output on the serial console. The management and service ports are no longer accessible, and they will not respond to a ping.
  • The X7 director will continue to operate, but will only have a single functional CP.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device