Exciting new changes are coming to the Knowledge Base site soon!
Starting April 4, 2023, you will notice Support-Specific categorization and improvements to the search filters on the site. In May, we will be launching a new and enhanced Site UI and Navigation. To know more, read our Knowledge Article.

Home
Advice and Troubleshooting
Data Storage Systems
Fabric, Interconnect and Management Switches
Upgrading Nexus 3132 cluster network switch causes it to drop into switch boot prompt

Upgrading Nexus 3132 cluster network switch causes it to drop into switch boot prompt

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 666

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: hw

Last Updated:

Applies to

Cisco Nexus 3000 series switches

Issue

When upgrading a Nexus 3000 series with compact or full image to release 7.0(3)I7(7) or 7.0(3)I7(8), it will reload and comes up in switch boot prompt.
Following error is seen:

Trim files after extracting TOR files ...

error while upgrading the firmware

/mnt/cfg/1 dir return 32 <<<<<<<<<<<<<<<<<<<<<



Config partitions are not partitioned properly.\nDisk will be re-initialized. <<<<<<<<<<<<<<<<<<<<<

switch(boot)#

prompt is then shown