Skip to main content
NetApp Knowledge Base

Service port configuration conflicts with the configured IP Address in CN1610 switch

Views:
157
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

CN1610 cluster switches

Issue

  • Ping/SSH does not work on CN1610 cluster switch, as the service port is not properly configured with an IP address:

(Switch)#show serviceport

Interface Status............................... Up
IP Address..................................... 0.0.0.0
Subnet Mask.................................... 0.0.0.0
Default Gateway................................ 0.0.0.0

IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::2a0:94ff:feef:560e/64
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Burned In MAC Address.......................... 00:A0:96:EF:56:0E

  • Service port configuration conflicts with the configured IP address in the switch.

(Switch)#serviceport ip 172.70.10.10 255.255.255.0 172.70.10.1

IP Address/Netmask entered conflicts with the configured IP Address/Netmask of
the switch.

  • It can be found that the same IP address is assigned to the network port.

(Switch)#show network

Interface Status............................... Up
IP Address..................................... 172.70.10.10
Subnet Mask.................................... 255.255.255.0
Default Gateway................................ 172.70.10.1

IPv6 Administrative Mode....................... Enabled
IPv6 Prefix is ................................ fe80::2a0:94ff:feef:560e/64
Burned In MAC Address.......................... 00:A0:98:EF:58:0D
Locally Administered MAC address............... 00:00:00:00:00:00
MAC Address Type............................... Burned In
Configured IPv4 Protocol....................... None
Configured IPv6 Protocol....................... None
IPv6 AutoConfig Mode........................... Disabled
Management VLAN ID............................. 1

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device