Skip to main content
NetApp Knowledge Base

Brocade switch reporting high temperature and "overheating"

  1. Last updated
  2. Save as PDF
Views:
806
Visibility:
Public
Votes:
2
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade G620

Issue

One of the temperature sensors reports a high value

error.PNG

  • Verified sensor status

/fabos/cliexec/sensorshow:
sensor  1: (Temperature) is Ok, value is 39 C
sensor  2: (Temperature) is Ok, value is 48 C
sensor  3: (Temperature) is Ok, value is 44 C
sensor  4: (Temperature) is Ok, value is 42 C
sensor  5: (Temperature) is Ok, value is 42 C
sensor  6: (Temperature) is Ok, value is 37 C
sensor  7: (Temperature) is Ok, value is 63 C
sensor  8: (Fan        ) is Ok,speed is 8141 RPM
sensor  9: (Fan        ) is Ok,speed is 8239 RPM
sensor 10: (Power Supply) is Faulty
sensor 11: (Power Supply) is Ok

  • The average temperature value of all the active sensors (in the above example all 7) should be averaged out

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.