Skip to main content
NetApp Knowledge Base

Brocade SanNav zoning function is not updated properly

Views:
604
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
san
Last Updated:

Applies to

  • Brocade
  • SanNav 2.1

Issue

  • Created new zone aliases and zones through SANnav Portal
  • While editing the Defined Zone configuration, the zone configuration does not change from Defined to Modified.
  • After opening the defined configuration, the zone(s) that were previously removed, are still present.
  • While creating new Zone Aliases, the Connected Product Port  names display the old value. However, under Inventory -> Storage Ports and on the SAN switch, these names are correct.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.