Skip to main content
NetApp Knowledge Base

AFF A400 e3a or e3b ports do not link up with BES-53248 cluster switch

Views:
536
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

Issue

  • Links do not come up between the cluster ports on the X1151 card and BES-53248 switch ports.
  • Switch port output example:

(switch)# show port 0/53-0/54
                 Admin     Physical   Physical   Link   Link    LACP   Actor
Intf      Type   Mode      Mode       Status     Status Trap    Mode   Timeout
--------- ------ --------- ---------- ---------- ------ ------- ------ --------
0/53             Enable    100G Full             Down   Enable  Enable long
0/54             Enable    100G Full             Down   Enable  Enable long

  • Node cluster port output example:

dbnass5215::> network port show -ipspace Cluster
                                                  Speed(Mbps) Health
Port      IPspace      Broadcast Domain Link MTU  Admin/Oper  Status
--------- ------------ ---------------- ---- ---- ----------- --------
e3a       Cluster      -                down 9000  auto/auto  -
e3b       Cluster      -                down 9000  auto/auto  -

  • ONTAP EMS messages:

ERROR netif.sfpNotSupported: The SFP+ or QSFP+ module (not supported ) installed in e3a is not supported with this network interface.
ERROR netif.sfpNotSupported: The SFP+ or QSFP+ module (not supported ) installed in e3b is not supported with this network interface.

Scan to view the article on your device
CUSTOMER EXCLUSIVE CONTENT

Registered NetApp customers get unlimited access to our dynamic Knowledge Base.

New authoritative content is published and updated each day by our team of experts.

Current Customer or Partner?

Sign In for unlimited access

New to NetApp?

Learn more about our award-winning Support