Skip to main content

NetApp_Insight_2020.png 

NetApp Knowledgebase

Switch port 'x' is in an unhealthy state/ Errors on switch port 'x'

Views:
102
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
san
Last Updated:

Applies to

  • Fiber Channel Protocol (FCP)
  • SAN
  • Brocade
  • Cisco

 

Issue

A switch port in Brocade/Cisco is in an unhealthy state or there are several errors on a switch port.

  • Switch logs (Brocade):
2020/03/10-10:20:06, [C4-1010], 13033, SLOT X CHASSIS, CRITICAL, Brocade_XX-X, X,X: Above normal hardware errors were observed: fault1:0x64, fault2:0x64 thresh2:0xb0000064.2019/06/01-08:39:16, [C3-1014], 74, CHASSIS, WARNING, xxxxx,  Link Reset on Port Sx,Px(x) vc_no=0 crd(s)lost=x auto trigge
  • Switch logs (Cisco):

2020 Aug 25 04:26:00 %PORT-5-IF_DOWN_NOS_RCVD: %$VSAN 451%$ Interface fc1/13 is down (NOS received)

  • Low TX or RX Power values:
 
RX Power:    -40.0   dBm (0.1  uW)   31.6   uW  1258.9 uW  31.6   uW   794.0  uW
TX Power:    -2.2    dBm (600.1 uW)  126.0  uW  1258.9 uW  251.0  uW   794.0  uW
 
  • Performance issues:
2020/05/19-20:08:21, [AN-1010], 687622, FID 128, WARNING, XXXX, Severe latency bottleneck detected at slot 0 port 
 
 

 

CUSTOMER EXCLUSIVE CONTENT

Registered NetApp customers get unlimited access to our dynamic Knowledge Base.

New authoritative content is published and updated each day by our team of experts.

Current Customer or Partner?

Sign In for unlimited access

New to NetApp?

Learn more about our award-winning Support