Skip to main content
NetApp Knowledge Base

Reboot is observed on the Brocade GEN 6 platform when customers are using CLI scripting

  1. Last updated
  2. Save as PDF
Views:
184
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
brocade
Last Updated:

Applies to

  • Brocade GEN 6 switches
  • 8.2.1b

Issue

  • Silent Reboot is observed on the X6 platform when customers are using CLI scripting
    • Symptom is an HA Fail-Over with no reason given and no core dump.
  • Switch Hang is observed on GEN 6 switches when customers are using CLI scripting  
    • Symptom is the switch will not be reachable from SANNAV and will appear to "hang" 
    • Host traffic will still operate
    • CPU is no longer responsive and can no longer be managed until reboot
  • Trace Corruption failures are observed on GEN 6 switches when customers are using CLI scripting
    • Symptom is the core dump will fail or be incomplete and the stack trace will show a corruption in the tracing module
    • When user daemon terminates, a zero size core file will be produced.
  • This is only seen in GEN 6 Brocade Switches

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.