Skip to main content
NetApp Response to Russia-Ukraine Cyber Threat
In response to the recent rise in cyber threat due to the Russian-Ukraine crisis, NetApp is actively monitoring the global security intelligence and updating our cybersecurity measures. We follow U.S. Federal Government guidance and remain on high alert. Customers are encouraged to monitor the Cybersecurity and Infrastructure Security (CISA) website for new information as it develops and remain on high alert.
NetApp Knowledge Base

Is the Network Port DCB configurable on NetApp to match the Cisco Switch settings?

Views:
201
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP 9.x
  • FCoE
  • SAN
  • Cisco Nexus 5k Switches
  • Quality of Service (QoS)
  • Class of Service (CoS)
  • Data Center Bridging (DCB)

Answer

Any changes made with regards to QoS/CoS/ DCB on Cisco Switch should reflect immediately on NetApp Storage. There is no specific configuration change required from ONTAP.

Additional Information

Use dcb show command on ONTAP to verify the settings.

Example:

run -node <xxxx> -command dcb show

Interface  PGID  Priority           Application             Bandwidth
---------  ----  ----------         ------------         ------------
e3a                                                                  
           0     0 1 2 4 5 6 7      unassigned                   50% 
           1     3                  FCoE                         50% 
e3b                                                                  
           0     0 1 2 3 4 5 6 7    unassigned                    0% 
e4a                                                                  
           0     0 1 2 4 5 6 7      unassigned                   50% 
           1     3                  FCoE                         50% 
e4b                                                                  
           0     0 1 2 3 4 5 6 7    unassigned                    0% 

 

 

Scan to view the article on your device