Skip to main content
NetApp Knowledge Base

Is it possible to upgrade the existing RCF on a cluster network switch?

Views:
707
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco Nexus purchased from NetApp
  • Broadcom BES-53248 purchased from NetApp

Answer

  • No, the upgrade of the reference configuration file (RCF) is not supported
  • If a new RCF is required as part of a planned upgrade, the existing configuration should be wiped and a reload of the new config should be performed

WARNING

Wiping the existing configuration will need to be done over serial connection, as the ip address will also be removed from the switch

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.