Skip to main content
NetApp Knowledge Base

Brocade VDX8770 Linecard marked as faulty due to overheating issues

  1. Last updated
  2. Save as PDF
Views:
76
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
san
Last Updated:

Applies to

  • Brocade / Extreme Networks
  • Linecard LC48X10GT

Issue

Line card inserted into switch chassis is faulty which was burnt due to overheating issues.
 
SW_RB1# show linecard
Rbridge-id 1:
Slot Type Description ID Status
----------------------------------------------------------------------
L1 LC12X40G 12-port 40GE card 127 ENABLED
L2 LC12X40G 12-port 40GE card 127 ENABLED
L3 LC48X10G 48-port 10GE card 114 ENABLED
L4 LC48X10G 48-port 10GE card 114 ENABLED
L5 0 FAULTY (95)
L6 VACANT
L7 VACANT
L8 VACANT
 
The same line card reports faulty after reseating on a different slot :
 
2022/03/17-10:38:45, [EM-1034], 269371, M1 | Active, ERROR, VDX6740T-1G, L7 is set to faulty, rc=2005f.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.