Skip to main content
NetApp Knowledge Base

RCF Improperly Applied to Cluster Network Switch Requiring RCF Revert

  1. Last updated
  2. Save as PDF
Views:
1,318
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

Cisco Nexus (NX) Cluster Network Switches

Issue

  • An RCF has been improperly applied, and is noticed when reviewing the running configuration with the show running-config command; attempts to re-apply the correct RCF do not resolve the issue
  • Latency may be seen across cluster interconnect
  • Data may stop being served due to indirect traffic
  • Cluster network degraded Autosupport callhomes may be generated on a daily basis due to the following cluster network ping loss errors between all nodes in the cluster

HA Group Notification (CLUSTER NETWORK DEGRADED) ALERT

3/11/2022 17:49:59  node-01 ALERT vifmgr.cluscheck.ctdpktloss: Continued packet loss when pinging from cluster lif node-01_clus2 (node node-01) to cluster lif node-02_clus1 (node node-02).


 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.