Skip to main content
NetApp Knowledge Base

Is the Network Port DCB configurable on NetApp to match the Cisco Switch settings?

Views:
353
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP 9.x
  • FCoE
  • SAN
  • Cisco Nexus 5k Switches
  • Quality of Service (QoS)
  • Class of Service (CoS)
  • Data Center Bridging (DCB)

Answer

Any changes made with regards to QoS/CoS/ DCB on Cisco Switch should reflect immediately on NetApp Storage. There is no specific configuration change required from ONTAP.

Additional Information

Use dcb show command on ONTAP to verify the settings.

Example:

run -node <xxxx> -command dcb show

Interface  PGID  Priority           Application             Bandwidth
---------  ----  ----------         ------------         ------------
e3a                                                                  
           0     0 1 2 4 5 6 7      unassigned                   50% 
           1     3                  FCoE                         50% 
e3b                                                                  
           0     0 1 2 3 4 5 6 7    unassigned                    0% 
e4a                                                                  
           0     0 1 2 4 5 6 7      unassigned                   50% 
           1     3                  FCoE                         50% 
e4b                                                                  
           0     0 1 2 3 4 5 6 7    unassigned                    0% 

 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.