Skip to main content
NetApp Knowledge Base

After switch reboot, CLUSTER NETWORK DEGRADED ALERT seen SwitchIfIslDownWarn_Alert

  1. Last updated
  2. Save as PDF
Views:
676
Visibility:
Public
Votes:
1
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • CN1610 cluster switch
  • BES-53248 cluster switch

Issue

  • Switch rebooted after a power outage or maintenance. 
  • The system reports the following CLUSTER NETWORK DEGRADED alerts in event logs:

[Node-01: vifmgr: callhome.clus.net.degraded:alert]: Call home for CLUSTER NETWORK DEGRADED: Total Packet Loss - Ping failures detected between Node-01_clus2 ( 169.XXX.XX.XXX ) on Node-01 and Node-04_clus1 ( 169.XXX.XX.XXX ) on Node-04

  • If using ISL LAG (link aggregate), you may see this ASUP alert:(Health Monitor process cshm: SwitchIfIslDownWarn_Alert[<switch_name>/<LAG_name>]) ALERT
  • In event logs:

[Node-04: cshmd: hm.alert.raised:alert]: Alert Id = SwitchIfIslDownWarn_Alert , Alerting Resource = cluster-sw1/ Link Aggregate 1 raised by monitor cluster-switch

  • The switch health is degraded:

eu10380sc1::> system health subsystem show
Subsystem         Health
----------------- ------------------
SAS-connect       ok
Environment       ok
Memory            ok
Service-Processor ok
Switch-Health     degraded
CIFS-NDO          ok
Motherboard       ok

  • Switch show tech-support reports ISL ports disabled and down:

Switch# show port all

                 Admin     Physical   Physical   Link   Link    LACP   Actor
Intf      Type   Mode      Mode       Status     Status Trap    Mode   Timeout
--------- ------ --------- ---------- ---------- ------ ------- ------ --------
0/13      PC Mbr Disable   10G Full              Down   Enable  Enable long
0/14      PC Mbr Disable   10G Full              Down   Enable  Enable long
0/15      PC Mbr Disable   10G Full              Down   Enable  Enable long
0/16      PC Mbr Disable   10G Full              Down   Enable  Enable long

  • In the show running-config output of the switch, we see that all the ISL ports are shutdown:

    interface 0/13
    shutdown
    description 'ISL member port 13'
    mtu 9216
    exit
    interface 0/14
    shutdown
    description 'ISL member port 14'
    mtu 9216
    exit
    interface 0/15
    shutdown
    description 'ISL member port 15'
    mtu 9216
    exit
    interface 0/16
    shutdown
    description 'ISL member port 16'
    mtu 9216
    exit

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.