Skip to main content
NetApp Knowledge Base

e0a, e0b, e0M, e0P are missing

Views:
131
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

FAS2552

Issue

sysconfig -a reports e0a, e0b, e0M, e0P are missing.

Service Processor Status: Online
Firmware Version: 2.8P1
Mgmt MAC Address: 00:A0:98:CC:1F:E2
Ethernet Link: up, full duplex, auto-neg complete
Using DHCP: no
IPv4 configuration:
IP Address: 192.168.254.25
Netmask: 255.255.255.0
Gateway: 192.168.254.254
IPv6 configuration: Disabled
[Service Processor cached network information determined at Fri Mar 18 14:23:28 CST 2022]
slot 0: Internal 10/100/1000 Ethernet Switch
Wrench: auto-1000t-fd-up
Locked-wrench: auto-1000t-fd-up
Device Type: 88E6176
slot 0: 1G/10G Ethernet Controller CNA EP 8324
(Multiple Dual-port, QLogic CNA 8324(8362) rev. 2)
e0c MAC Address: 00:a0:98:cc:1f:e4 (auto-10g_sr-fd-up)
e0d MAC Address: 00:a0:98:cc:1f:e5 (auto-10g_sr-fd-up)
e0e MAC Address: 00:a0:98:cc:1f:ea (auto-10g_twinax-fd-up)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device