Skip to main content
NetApp Knowledge Base

e0a, e0b, e0M, e0P are missing

Views:
489
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

FAS2552

Issue

sysconfig -a reports e0a, e0b, e0M, e0P are missing.

Service Processor Status: Online
Firmware Version: 2.8P1
Mgmt MAC Address: 00:A0:98:CC:1F:E2
Ethernet Link: up, full duplex, auto-neg complete
Using DHCP: no
IPv4 configuration:
IP Address: 192.168.254.25
Netmask: 255.255.255.0
Gateway: 192.168.254.254
IPv6 configuration: Disabled
[Service Processor cached network information determined at Fri Mar 18 14:23:28 CST 2022]
slot 0: Internal 10/100/1000 Ethernet Switch
Wrench: auto-1000t-fd-up
Locked-wrench: auto-1000t-fd-up
Device Type: 88E6176
slot 0: 1G/10G Ethernet Controller CNA EP 8324
(Multiple Dual-port, QLogic CNA 8324(8362) rev. 2)
e0c MAC Address: 00:a0:98:cc:1f:e4 (auto-10g_sr-fd-up)
e0d MAC Address: 00:a0:98:cc:1f:e5 (auto-10g_sr-fd-up)
e0e MAC Address: 00:a0:98:cc:1f:ea (auto-10g_twinax-fd-up)

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.