Skip to main content
NetApp Knowledge Base

Why does snmp.warmstart.trap message output?

Views:
258
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

ONTAP 9

Answer

  • The message below occurs when the SNMP daemon is reinitializing itself with a warmStart.
Sun Oct 18 00:30:23 JST [XXXXX-01: mgwd: snmp.warmstart.trap:info]: SNMP daemon was reinitialized with no configuration changes.
  • A warmStart(1) trap signifies that no configuration changes are made to the agent or the protocol entity implementation during the reinitialization.
  • This message can be ignored due to it is not an error message.
  • Management Gateway (mgwd) subsystem restart is also observed.

Additional Information

additionalInformation_text

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.