Skip to main content
NetApp Knowledge Base

Unidentified/New Disk Error: Device qualification failure

Views:
565
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP operating in 7-Mode

Issue

If an unidentified HDD is inserted into the system, the storage controller's Event Management Systems (EMS) will log an error message similar to the one below:

  • Error message

Tue Oct 9 10:28:58 GMT [disk.dynamicqual.failure.occurred:error]: Device qualification failure occurred. Please refer to the qual_devices man page for corrective action. This problem must be corrected within 72 hour(s) to avoid a forced system shutdown. The following disk(s) remain unqualified:

  • Error messageThe following drive is not qualified by NetApp. For a list of qualified drives, please contact NetA
  • Error messageDevice qualification failure detected
  • Error messageDev Qual failure timeout expired. Halting system.

 

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.