Skip to main content
NetApp Knowledge Base

Unable to join node to cluster due to Unused cluster ports

  1. Last updated
  2. Save as PDF
Views:
396
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • FAS8300

Issue

  • Joining a node to a cluster results in the following error:
Trying to join cluster again as previous attempt
failed ....Error: Unused cluster ports exist in the cluster. One or more ports may not be in the "healthy" state, or may be
incorrectly assigned to the "Cluster" Ipspace. Run "network port show -ipspace Cluster" to view the cluster ports. Correct any
issues, and then try the command again.

Resolve the issue, then try the command again.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.