Skip to main content
NetApp Knowledge Base

QLogic FC/10GbE CNA Panic after Upgrade to ONTAP 9.2

Views:
438
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9.2 or later
  • Node has a QLogic CNA Adatper (On-board or Expansion Card in a slot)

Description

  • Controller panics with the following message:

PANIC: PCI Error NMI from device(s):RPT(0,3,0):QLogic FC/10GbE CNA on Controller. in SK process pmcsas_admin_1 on release 9.2P2 (C) on Sun Jan 21 00:50:06 CST 2018version: 9.2P2: Sat Dec 9 13:46:04 PST 2017

  • A defect was found in the Network drivers in 9.2x and the interaction of the TSO, mulitple VLANs and data traffic pattern.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.