Skip to main content
NetApp Knowledge Base

Port e0c e0d e0e e0f can't be identified after power cycle

Views:
332
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

FAS2650

Issue

After power cycle, port e0c e0d e0e e0f can't be identified from sysconfig -a.
 
slot 0: 10 Gigabit Ethernet Controller IX5-SFP+
e0a MAC Address: 00:a0:98:dd:21:07 (auto-10g_twinax-fd-up)
    SFP Vendor: Molex Inc.
    SFP Part Number: 747529718
    SFP Serial Number: XXXXXXXXX
e0b MAC Address: 00:a0:98:dd:21:08 (auto-10g_twinax-fd-up)
    SFP Vendor: Molex Inc.
    SFP Part Number: 747529718
    SFP Serial Number: XXXXXXXXX
 Device Type: X550EM
 Firmware Version: 0.86-7.1 (20150807-0701)
slot 0: PLX DMA Engine 2 (PLX87d0)
 State: Active
slot 0: Interconnect HBA: Generic OFED Provider
 Port Name: ic0a
 GID: XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX
 Base LID: XXXXX
 Active MTU: 8192

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device

 

  • Was this article helpful?